Quiznetik
Structural Design and Drawing | Set 2
1. Which of the following statement is true?
A. lap joint eliminates eccentricity of applied load, butt joint results in eccentricity at connection
B. lap joint and butt joint eliminates eccentricity at connection
C. lap joint results in eccentricity of applied load, butt joint eliminates eccentricity at connection
D. lap joint and butt joint results in eccentricity of applied load
Correct : C. lap joint results in eccentricity of applied load, butt joint eliminates eccentricity at connection
2. In a lap joint, at least bolts should be provided in a line.
A. 0
B. 1
C. 2
D. 3
Correct : C. 2
3. Use of lap joints is not recommended because
A. stresses are distributed unevenly
B. eccentricity is eliminated
C. bolts are in double shear
D. no bending is produced
Correct : A. stresses are distributed unevenly
4. Why is double cover butt joint preferred over single cover butt joint or lap joint?
A. bolts are in single shear
B. eliminates eccentricity
C. bending in bolts
D. shear force is not transmitted
Correct : B. eliminates eccentricity
5. Clip and seating angle connection is provided for
A. lateral support
B. bending support
C. frictional support
D. hinged support
Correct : A. lateral support
6. In flexible end plate design, beam is designed for the
A. maximum bending moment
B. shear force
C. torsional moment
D. zero end moment
Correct : D. zero end moment
7. which of the following condition is true for web side plate connection?
A. hsfg bolts should be used
B. bolts should be designed to fail by shear of bolt
C. bolts should be designed to fail by bearing of connected plies
D. edge distances must be less than two times the bolt diameter
Correct : C. bolts should be designed to fail by bearing of connected plies